Camp 10.0 Matt Long

3 YEAR WARRANTY

8 (ASTM F3340-18)

2610 g

100% Polyester 50D Stretch

198 x 77 x 10 cm

80 x 23 cm

high density polyurethane foam 16 kg/m2

When inflating a mattress, do not use any inflation pumps, pumps, etc. Avoid leaving an inflated mattress (with closed valve) in a tent, car or direct sunlight during hot days. Protect it from open flame, sparks, hot heating body, lamp or any other heat source. Moreover, protect the mattress surface from strongly chlorinated water e.g. swimming pool water. Select suitable place to locate and use the mattress and prevent from puncture or damage. Take care of sharp stones, gravel, limbs, pinnacles, dry grass and other sharp objects. Upon a mattress puncture, use enclosed glue and patches according to the manual. Mattress shall be stored in expanded state (best possible flat) with open valve. So the foam filling preserves its extensibility, collected moisture may escape and the non-permeable layer shall not be damaged by moisture, mildew or other microorganisms. Avoid the mattress storage on wet and humid place (relative humidity up to 60 %) at the temperature of 0° C up to +40° C. Make sure of that the mattress is dry before storing. Clean with soft detergents on soap basis, tepid water and soft swab or rag. The valve shall be closes to prevent from water penetration inside. Dry the mattress in extended state with open valve on air. In no case, dry it on direct sunlight or heat source.